X-10 SIREN

Passive Coupler. 1:1 ratio. Installs at the electrical panel to couple both phases of the 240V circuit. Recommended for installations under 3000 sq. feet.

Plug-in noise filter for isolating a specific appliance. (5A). These devices can be retrofitted, see the troubleshooting article on page 4.

3 wire noise filter for installation at the fixture or electrical panel. (20A).

X10 WZB16 4 Hour Battery Pack for Wvk54 Wireless Camera

Power line interfaces connect via RJ11 to the X10 output of another manufacturer's device (cable not included) and injects the valid data signals from the device to the AC power ...

Wall receptacle with an appliance module built in. Can turn devices plugged in to the module on or off.

The 3 terminal control module (AM466) is general purpose control module which includes the ground pin. It can be used for switching resistive as well as inductive loads.

Coupler/Repeater. Installs at the electrical panel to couple and repeat X10 command signals at the higher amplitude on split and three phase panels.

The 3-phase 250A Signal Blocking Coupler is designed to be attenuate (at a rate of 30:1) X-10 power line carrier signals from crossing from one household to another via the AC ...

Standard Transmitter Base fits inside a single gang box and wires directly to Hot and Neutral.

Used in conjunction with the XPT (wall transmitter base) the following variations are available on/off control of one X10 number code all lights on/all units off within one ...

A matched set of wall transmitter base (XPT) and a 1 button keypad (XP1) used to transmit directly onto the AC power line. With the direct control of 4 sequential X10 commands.

POWERFLASH SECURITY INTERFACE Burg-alarm Interface connects to the dry contact closures or low-voltage output from an existing alarm panel or other device and sends 1 of 3 signals ...

Noise reducer. Wires in at the branch circuit or at the line leads of the affected module to help solve Hard-to-find or intermittent noise issues.